Filter
Top Products
7
®
Programming Stand-Alone
Access Control Systems
using TELPRO™ Programmer.
MLP3 Proximity
MIR Infra-Red
MILBCard Reader
LB20Swipe Card
ECP190
ECP290
ECP100
ECP200
Access Control Modules, Readers, Receivers without integral Infra-Red
Access Control Modules with integral Infra-Red
The TELPRO™
Programmer is
supplied with a
connector cable.
Simply connect to
ECP Door Controller
to program.
The TELPRO™ Programmer
can be used as a wirefree
infra-red programmer. Simply
point at the reader/receiver
module to program.
TELPRO™
Programmer
TELPRO™
Programmer
If the entrance or door panel includes a MICAM/MICIM Keypad Module connected to the ECP Door Controller, all
programming can be effected directly via the MICAM/MICIM Keypad ie. TELPRO™ Programmer would not be
required.You would also then have the option of having keypad access codes.
LTP03
Office Proximity Reader
Dim:
120L x 60W x 25D
TELPRO™ PROGRAMMER
The TELPRO™ Programmer is a handheld
keypad used for programming Noralsy
®
stand-alone access control systems.
Installation companies only ever need 1n
o
.
TELPRO™ Programmer.
TELPRO™ can be used on any system
provided, of course, the Master Code (also
referred to as the Engineer Code) which
grants access into programming mode is
known or, access to the ECP Door Controller
itself is available.
The final customer only needs a TELPRO™
unit if they wish to effect programming
themselves.
All measurements in millimetres.
LHF
Radio receiver