Filter
Top Products
11
After a beep enter on the TELPRO:
A sharp beep confirms that you have correctly deleted Holder Number 074. Programming mode beep - every 4
seconds - resumes.
Example C: Validation of 1n
o
. Access Pass
You have just received the additional Access Pass ordered for Alan Jones who had lost his earlier in the week. The last
3n
o
. digits on the Access Pass are 176. Alan Jones is now Holder Number 176 and you have to program the system to
accept Holder Number 176.
Enter the Master Code 19388 on the TELPRO. Beeps every 4 seconds indicate that you have accessed Programming
Mode.
After a beep enter on the TELPRO:
A sharp beep confirms that you have correctly programmed new Holder Number 176. Programming mode beep - every
4 seconds - resumes.
Example D: Block Deletion of Access Passes
You have just been informed that a set of 20 Access Passes reserved for visitors and held in reception have been
stolen. You have to immediately delete them to restore system security. The Holder Numbers stolen were 080-099.
Enter the Master Code 19388 on the TELPRO. Beeps every 4 seconds indicate that you have accessed Programming
Mode.
After a beep enter on the TELPRO:
A series of 3n
o
. beeps followed by a sharper beep confirms that you have deleted the Holder Numbers. Programming
mode beep - every 4 seconds - resumes.
Example E: Changing the Relay/Lock Output Time
You have been asked to change the Relay Output Time to 12 seconds.
Enter the current Master Code 19388 on the TELPRO. Beeps every 4 seconds indicate that you have accessed
Programming Mode.
After a beep enter on the TELPRO:
A sharp beep confirms that you have correctly reprogrammed the relay output time for 12 seconds. Programming
mode beep - every 4 seconds - resumes.
Example F: Changing the Master Code
You have been asked to change the Master Code to 11821.
Enter the current Master Code 19388 on the TELPRO. Beeps every 4 seconds indicate that you have accessed
Programming Mode.
After a beep enter on the TELPRO:
A sharp beep confirms that you have correctly entered the new Master Code. Programming mode beep - every 4
seconds - resumes.