Filter
Top Products
C494M-E (9/06) 7
REPLACEMENT TAMPER SWITCH INSTALLATION
The HS2000 enclosure comes with a tamper switch installed. If you need to install a replacement switch, refer to Figure 1 for the correct position
of the switch and perform the following steps:
1. Remove the front cover.
2. Install the switch and secure with lock washers and nuts.
TAMPER SWITCH WIRING
The tamper switch comes with normally open and normally closed contacts.
For a normally open circuit, use the “open” and “common” terminals; for a normally closed circuit, use the “closed” and “common” terminals.
Figure 1.
HS2000 Series Tamper Switch Installation
BRACKET/SWITCH
MOUNTING PLATE