Pelco C2410M-J Home Security System User Manual


 
6 C2410M-J (2/08)
MOUNTING TO CEILING TILE
1. Remove the ceiling tile.
2. Using the adapter plate as a template, cut
a hole 3.5 inches (9 cm) in diameter in the
ceiling tile for the back box. Punch four
screw holes in the ceiling tile.
3. Attach the back box to the ceiling tile and
adapter plate with the four 8-32 x 1.25-inch
screws.
4. Replace the ceiling tile.
5. Remove an adjacent ceiling tile and connect the video cable.
6. Connect the power wires.
For 12 VDC, connect the 24 VAC/12 VDC (red) and GND (black) wires to input power. The blue
wire is not used.
For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power. The
black wire is not used.
INSTALL CAMERA
1. Some indoor installations do not require a
heater. If the installation does not require a
heater, remove the heater board from the
camera assembly. To remove the heater apply
pressure and press on the corner of the board.
2. 12 VDC Operation Only: The camera is set
for 24 VAC operation at the factory. For
12 VDC operation, remove the jumper from
the 24 VAC position and install it on the
12 VDC position.
WARNING: Heater elements could be hot! When camera power is on, use caution when adjusting
the camera. This applies to all models.
CEILING TILE
BACK BOX
ADAPTER PLATE
8-32 X 1.25
MOUNTING
HARDWARE
(SUPPLIED)
MOUNTING TO CEILING TILE
HEATER
BOARD
24 VAC JUMPER
12 VDC JUMPER
VIDEO
CONNECTOR
HEATER
CONNECTOR