Filter
Top Products
7 of 10
ISSUED: 10-01-10 SHEET #: 095-9354-3 12-13-10
Install two 1/4-20 x 1/2" thread forming screws (L) into lower mounting plate (C) leaving 1/8" exposed thread as
shown below.
5
C
L
Set control box into lower mount plate (C) and place assembly onto back of display. Adjust upper and lower
mounting plates (B,C) to align top mounting holes with ultra-slim wall mount bar.
Secure assembly to back of display by reinstalling two M4 chrome plated screws (included with display) into ultra-
slim wall mount bar, four M4 black phillips screws (included with display) into lower mounting holes of control box,
and four M4 x 16 mm phillips screws (M) into upper mounting holes of control box.
Tighten all fasteners.
4
M4 CHROME SCREWS
CONTROL
BOX
ULTRA-SLIM WALL
MOUNT BAR
DISPLAY
M4 BLACK SCREWS
M