Filter
Top Products
4 of 10
ISSUED: 10-01-10 SHEET #: 095-9354-3 12-13-10
Installation to Wood Stud Wall
Use a stud fi nder to locate the edges of the studs. Use of an edge-to-edge stud fi nder is highly recommended.
Based on their edges, draw a vertical line down each stud’s center. Center of screen mounting plate will be
2.5" offset from center of outer mounting slot as shown in fi gure 1.1 or will be 0.19" offset from center of inner
mounting slot as shown in fi gure 1.2. Place wall arm (A) on wall as template, level, and mark the center of four
mounting holes. Top mounting slot will be X" above the screen center as shown in fi gure 1.1 and chart 1.
Drill four 5/32" dia. holes to a minimum depth of 2.5". Secure wall arm (A) to wall with four wood screws (D) as
shown in fi gure 1.2. NOTE: Be sure arrow is pointing up when mounting wall arm (A) to wall as shown in fi gure
1.1. Level, then tighten all fasteners.
Insert eight fastener caps (G) into wall plate mounting holes.
G
A
D
fi g. 1.1
fi g. 1.2
1
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is fi rmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).
WARNING
X"
2.5"
(64 mm)
0.19"
(5 mm)
ARROW
= CENTER OF SCREEN
SCREEN
MOUNTING PLATE
for 46" display 10.7" (272mm)
for 55" display 9.1" (231mm)
Chart 1