Filter
Top Products
OFF/ON
OPERATION
TEMP/TIMER
C
O
O
L
F
A
N
H
IG
H
M
E
D
L
O
W
M
O
D
E
F
A
N
S
P
E
E
D
SET
TIMER
SET/
CANCEL
A
IR
S
W
IN
G
E
C
O
N
O
M
Y
h
r
¡F
W
ireless
R
e
m
o
te
C
o
n
tr
o
l
O
FF/O
N
OPERATION
T
E
M
P
/T
IM
E
R
COOL
FAN
HIGH
MED
LOW
MODE
FAN SPEED
S
E
T
T
I
M
E
R
SET/
C
A
N
C
EL
AIR SWING
E
C
O
N
O
M
Y
h
r
°
F
W
ireless
R
em
ote C
ontrol
INSTALLATION OF THE FRONT GRILLE
Depending upon the location
of the AC outlet, route the AC
cord to either the left or right
side while installing the front
grille.
This figure shows the AC cord
routed to the left side.
1 Place the front grille on
the cabinet first.
2 Secure the front grille to
the main chassis using
screw provided.
INSERT THE (OPTIONAL)
Attach the (part no.
CZ-SF6P) to the frame.
Slot in the and the
frame (part no. CZ-SFW6P) to
the front grille.
REMOVAL OF FRONT GRILLE
1 Remove the front intake grille.
Pull up the front intake
grille about 90° and slide
it slightly to the left to
unhook the tabs.
2 Remove the air filter.
Tilt up and pull out the air filter
by the holder.
Air filter
3 Remove the front grille.
Remove the adhesive tape from
all sides of the front grille.
At bottom right side of the front
grille, press inward on cabinet
near the power cord, and pull
the grille outward to the right
until right tab releases.
At the bottom left side, push
inward on cabinet and pull the
grille outward to the left to
release the left tab. Do not pull
the bottom edge toward you more than 3 inches to prevent the two
top tabs from damage.
Slide the front grille upwards to free the two top tabs from slots
at the top of the cabinet.
HOW TO ATTACH THE DRAIN PAN (OPTIONAL)
Maximum
13/32”
Condensed water
This air conditioner employs a
“Slinger-Up System” which is
designed to splash the condensed
water on the condenser coil for
maximum cooling efficiency, thus
producing a splashing sound.
If the splashing sound annoys you,
you can provide an outside drainage
by using the following procedure
which may, however, cause a small
loss of performance.
NOTE
The cabinet should be installed tilted
slightly lower to the rear for
necessary condensate drainage.
(Max. 13/32”)
Condensed water drainage
The and the frame can be obtained separately
from your nearest servicenter.
INSERT THE AIR FILTER
Attach the air filter to the intake grille.
PLACE FRONT INTAKE GRILLE OVER THE FRONT GRILLE
Slide the front intake grille slightly to the right to reattach the
tabs and then push it down to close tight.
Lift up about 90°.
OFF/ON
OPERATION
T
E
M
P
/T
IM
E
R
COOL
FAN
HIGH
MED
LOW
MODE
FAN SPEED
S
E
T
T
I
M
E
R
S
ET/
C
A
N
C
EL
AIR SWING
E
C
O
N
O
M
Y
h
r
°F
W
ireless
Rem
ote C
ontrol