Filter
Top Products
Page 22
All Lights On
At the ALL prompt, press the 1 (LIGHTS ON) key. The console will beep, and a command will be sent that turns all X-10 Lamp
Modules and all ALC Switch Modules On. X-10 Appliance Modules do not respond when the All Lights On command is sent.
All X-10 / ALC unit numbers 1 - 256, by factory default, respond to the All-On command.
NOTE: The All On function can be changed, if desired - See Set Up Misc, All On And All Off.
All Off
To turn off all modules (lamp and appliance modules included), at the ALL prompt, press the 0 (OFF) key. The console will
beep, and a command will be sent that turns all Modules off. All X-10 / ALC units, by factory default, respond to the All-Off
command.
NOTE: The All Off function can be changed, if desired - See Set Up Misc, All On And All Off.
Leviton Scene Control
HMS 1100 supports Leviton Scene Control (a feature found in certain Leviton Switches). There are 256 Scenes that can be set
and executed. The Leviton Switches are divided into "lighting groups" of four units each. Each of these lighting groups can be
set to four different Scenes. Once the Scenes have been set up, a command can be sent to the units in that Scene to simultaneously
return to the preprogrammed lighting level.
Scene
There are 256 Scenes that can be set and executed. The X-10 units (unit numbers 1-256) are divided into "lighting groups" of
four units each. Each of these lighting groups can be set to four different Scenes. Scenes 1-4 apply to the first four unit numbers
(units 1-4), Scenes 5-8 to the next four unit numbers (units 5-8), and so on. Thus an easy correspondence is made between Scene
numbers and unit numbers.
SCENES
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 X X X X
2 X X X X
3 X X X X
4 X X X X
5 X X X X
6 X X X X
7 X X X X
8 X X X X
9 X X X X
10 X X X X
11 X X X X
12 X X X X
13 X X X X
14 X X X X
15 X X X X
UNIT NUMBERS
16 X X X X
X - Corresponds to the unit numbers in a Scene.
Scene Commands
Scene Commands are used to Set Scenes, issue a Scene On command, and issue a Scene Off command. To issue Scene
Commands, press the 2 (SCENE) key. You are prompted to enter a Scene number.
ENTER SCENE:
1-64