OmniWare OWB Series Boiler User Manual


 
IMPORTANT
NOTICE TO OWNER
AND INSTALLER
To enjoy the long term benefits of burning your used oil in an Omni Waste Oil Boiler, it is
necessary to become familiar with the correct installation operation and maintenance of your new
boiler. Before installing or operating this appliance, make sure you read and understand this
manual.
IMPROPER INSTALLATION OR LACK OF
MAINTENANCE
WILL VOID THE WARRANTY
------------WARNING------------
Improper Installation, adjustment, alteration service or
maintenance can cause property damage, injury, or loss
of life. For assistance or additional information consult
a qualified installer or service agency. Read these
instructions carefully before installing
Identical to any oil burning appliance, without adequate draft over the fire, the combustion
gases cannot escape the appliance. The flame will lengthen resulting in an overheated
combustion chamber. Even if the heater is installed correctly and adequate draft achieved, a
flue passage blockage will affect the draft. Burning used oil is similar to burning wood. A fine gray
ash accumulates in the chamber and flue passage. This accumulation of ash will eventually affect
the draft. It is important to remove this ash before the draft is affected.
Note:
All illustrations and specifications contained herein are based on
the latest information available at time of publication approval.
Econo Heat reserves the right to make changes at any time
without notice, in material and specifications.
4
Installation, Operation, And Service Instructions