Filter
Top Products
CODE REQUIREMENTS
Installations must comply with all state, local, and utility codes, laws, regulations, and
ordinances, and CSA standard B139. Where required by the authority having
jurisdiction, the installation must conform to American society of Mechanical Engineers
Safety Code for Controls and Safety Devices for Automatically Fired Boilers, No. CSD-
1.
All electrical wiring must be done in accordance with the National Electrical codes latest
edition and all state and local codes.
STANDARD EQUIPMENT
* Factory Assembled Cast Iron Sections * Refractory Insulated Hinged front
* Flow Control Oil Supply Pump Door With Sight Glass
* Insulated Jacket * ASME Relief Valve 30 PSI
* Theraltimeter Gauge * Draft Inducer (optional)
* Boiler Drain * High Limit Aquastat Relay Combination
* Circulator – Except Models 35 and 50 (L-8148°) Except Models 35 and 50
* Relay – Models 35 and 50 Only * Serviceable Oil Filter
* Pre-built Control Manifold * Low Water Cut-off Control
Models 35 and 50 Only * Manual Reset High Limit Aquastat Control
12
Installation, Operation, And Service Instructions