Filter
Top Products
10-30
Page 74
2008-10-01
1. SUBMITTAL DESCRIPTIONS
A. INTRODUCTION
(1) The information found in this section is general in nature and consists of part
numbers, product descriptions and options, dimensions, specifications and
equipment features.
B. NH UNIT
(1) The different wiring connections to the humidifier unit can be found in Figure 2. All
wiring is to be in accordance with existing national and local electrical codes.
(2) Performance data for single and double units can be found in Figure 3, Figure 4,
and Figure 5.
(3) NH Series unit options and common accessories universal are found in Tables 1
and 2.
C. DISTRIBUTORS
(1) A description of the accessories for the steam distributor can be found in Table 3.
(2) Dimensions for the steam distributor are found in Figure 6, Figure 7, Figure 8.
D. SAM-e
(1) This section identifies the dimensions for the various configurations and
components that make up a SAM-e installation.
(2) General dimensions for the SAM-e and Mini SAM-e are found in Figures 9 and 10.
(3) For an in-duct/AHU installation without mounting frame refer to Figure 11.
(4) For an in-duct/AHU installation with mounting frame refer to Figure 12.
(5) For an outside duct installation without mounting frame refer to Figure 13.
(6) For an outside duct installation with mounting frame refer to Figure 14.
(7) For a vertical duct installation refer to Figure 15.
(8) For outside duct mounting cover plates refer to Figure 16.
(9) For atmospheric SAM-e adapter dimensions refer to Figure 17.
(10) For atmospheric steam header and adapter configuration refer to Figure 18.
E. BLOWER PACK
(1) Remote Blower Packs
(a) Remote blower packs are powered from the NH humidifier from a primary
voltage terminal block provided and fed from the leaving side of the unit
contactor to operate blower pack in conjunction with unit operation. A matching
terminal block is incorporated in the blower pack. Field wiring is required