Filter
Top Products
7
W415-0171 / D / 01.06.04
FIGURE 10
FIGURE 11
POSITIONING THE LOGS IMPROPERLY WILL CAUSE
FLAME IMPINGEMENT AND CARBONING.
PHAZER
TM
logs and charcoal embers, exclusive to Napo-
leon Fireplaces, provide a unique and realistic glowing
effect that is different in every installation. Take the time to
carefully position the charcoal embers for a maximum glow-
ing effect.
Randomly place the embers along the front burner ports.
Keep ember dust away from burner ports to avoid plugging
them.
Fine dust found in bottom of bag not to be used.
PHAZER
TM
logs and charcoal embers glow when exposed
to direct flame. Use only certified PHAZER
TM
logs and char-
coal embers available from your Napoleon dealer.
1. Place the front log onto the main burner, pushing it as
close as possible to the burner ports without
blocking/covering them. The left and right spacing between
the log ends and the burner ports should be equal.
2. Place the back log onto the log support brackets located
on the rear wall of the combustion chamber. The notch
situated at the lower left of the back log should be centred
evenly above the pilot assembly.
3. While supporting the back log, to prevent it from falling
forward, set the three smaller logs into the pockets and
grooves of the front and back logs, respectively.
Log colours may vary. During the initial use of the fire-
place, the colours will become more uniform as colour
pigments burn in during the heat activated curing proc-
ess.
LOG PLACEMENT
CHARCOAL EMBERS