Filter
Top Products
8
W415-0223 / D / 01.12.04
Positioning the logs improperly will cause flame im-
pingement and carboning.
PHAZER
TM
logs and glowing embers, exclusive to Napoleon
Fireplaces, glow when exposed to direct flame and provide
a unique and realistic glowing effect that is different in every
installation. Take the time to carefully position the glowing
embers for a maximum glowing effect. Use only certified
PHAZER
TM
logs available from your Napoleon / Wolf Steel
Ltd. dealer.
1. Place the rear log (#1) onto the two log supports and
against the air intake pipe.
2. Position logs #2 and #3 against the grate posts and line up
the studs located on the burner with the holes on the bottom
of the logs. Keep slightly back of the front row of ports.
3. Fit the centre log (#4) into place behind log #3 and into
the pocket provided on the back log.
This can vary according to the mantle depth. Use the graph
to help evaluate the clearance needed.
4. Tear the glowing embers into pieces and place along
the front row of ports covering all of the burner area in front
of the logs. Care should be taken to shred the embers into
thin, small irregular pieces as only the exposed edges of
the fibre hairs will glow. The ember material will only glow
when exposed to direct flame; however, care should be
taken to not block the burner ports. Blocked burner ports
can cause an incorrect flame pattern, carbon deposits and
delayed ignition.
Log colours may vary. During the initial use of the fireplace,
the colours will become more uniform as colour pigments
burn in during the heat activated curing process.
FIGURE 17
M
ANTLE WIDTH
H
E
I
G
H
T
M
A
N
T
L
E
FIGURE 16
LOWER DOOR BRACKET
#3
#2
#1
FIGURE 12
FIGURE 13
FIGURE 14
#4
Place the door into the two lower door brackets, and se-
cure at the top of the unit with two #10-24 machine screws.
FIGURE 15
GLOWING EMBERS
Remove the backing of the logo supplied and place on the
glass viewing door, as indicated.
½”
½”
LOGO
LOG PLACEMENT DOOR INSTALLATION
MANTLE CLEARANCE
LOGO PLACEMENT
FIGURE 18