Filter
Top Products
8
W415-0384 / D / 09.13.05
Purge all gas lines with the glass door open. Assure
that a continuous gas flow is at the burner before clos-
ing the door. Allow several minutes (5-15) for the flame
to stabilize after ignition.
Do not operate the main burner of the in-
sert with the door opened.
When lit for the first time, the fireplace will emit a slight
odour for a few hours. This is a normal temporary con-
dition caused by the "burn-in" of paints and lubricants
used in the manufacturing process and will not occur
again. Simply open a window to sufficiently ventilate
the room. After extended periods of non-operation such
as following a vacation or a warm weather season, the
fireplace may emit a slight odour for a few hours. This
is caused by dust particles in the heat exchanger burn-
ing off. Open a window to sufficiently ventilate the room.
PURGE THE GAS LINE WITH THE GLASS DOOR OPEN.
OPERATION / MAINTENANCE
OPERATING INSTRUCTIONS
The upper louvres must be removed to allow the door to be
opened or closed. Release the top and bottom door latches,
located at the right side of the door.
FIGURE 7
MANTLE WIDTH
H
E
I
G
H
T
M
A
N
T
L
E
This can vary according to the mantle depth. Use the graph
to help evaluate the clearance needed.
FIGURE 6
DOOR OPERATION
MANTLE CLEARANCE
DOOR LATCH