Filter
Top Products
15
W415-0319 / E / 01.17.07
L36 LOUVRE INSTALLATION
FIGURE 32 a-c
HOOD
Attach the hood by pressing the
top flange into the clips along
the top of the louvre opening.
Secure using a screw through
the centre slot.
LOWER LOUVRES
Insert the hinge clips into the
slots located at the bottom left
and right corners of the unit.
To remove the louvres, pull the
back tabs of the clips forward,
while pushing the louvre assem-
bly back. Lift the clip.
UPPER LOUVRES
Insert the louvre tabs into the
slots located at the top left and
right corners of the unit.
SLOT
TAB
B
C
HINGE
CLIP
SLOT
A
B
C
Remove the backing of
the logo supplied and
place on the screen
cover, as indicated.
LOGO PLACEMENT
A
CLIPS
FLANGE
When using a non-combustible finishing material, the
stand-offs may be removed, by removing the set screw in
the centre and sliding the stand-offs out of the mounting
clips.
HEAT SHIELD STAND-OFF
REMOVAL
HEAT SHIELD
STAND-OFFS
END HEAT SHIELD SHOWN
FIGURE 33
FIGURE 34
CENTRE
SLOT