Napoleon Fireplaces EF30 Indoor Fireplace User Manual


 
W415-0675 / A / 03.28.08
4
When using electric appliances, basic precautions should
always be followed to reduce the risk of fi re, electric shock,
and injury to persons, including the following:
1. Read all instructions before using this fi replace.
2. This fi replace is hot when in use. To avoid burns, do not
let bare skin touch hot surfaces. If provided, use handles
when moving this fi replace. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes, and
curtains at least 3 feet (0.9 meters) from the front of the
fi replace and keep them away from the sides and rear.
3. Extreme caution is necessary when this fi replace is used
by or near children and whenever the fi replace is left operat-
ing and unattended.
4. Always unplug fi replace when not in use.
5. Do not operate this fi replace with a damaged cord or
plug after the fi replace malfunctions, has been dropped
or damaged in any manner. Return fi replace to authorized
service facility for examination, electrical or mechanical
adjustment, or repair.
6. Do not use outdoors.
7. This fi replace is not intended for use in bathrooms,
laundry areas and similar indoor locations. Never locate
fi replace where it may fall into a bathtub or other water
container.
8. Do not run cord under carpeting. Do not cover cord with
throw rugs, runners, or the like. Arrange cord away from
traffi c area and where it will not be tripped over.
9. To disconnect fi replace, turn controls to off, then remove
plug from outlet.
10. Connect to properly grounded outlets only.
11. Do not insert or allow foreign objects to enter any ven-
tilation or exhaust opening as this may cause an electric
shock or fi re, or damage the fi replace.
12. To prevent a possible fi re, do not block air intakes or
exhaust in any manner. Do not use on soft surfaces, like a
carpet, where openings may become blocked.
13. Use this fi replace only as described in this manual.
Any other use not recommended by the manufacturer may
cause fi re, electric shock, or injury to persons.
14. Avoid the use of an extension cord because the exten-
sion cord may overheat and cause a risk of fi re. However,
if an extension cord must be used, the cord shall be No.14
AWG minimum size and rated not less than 1875 watts.
SAVE THESE INSTRUCTIONS.
READ THESE INSTRUCTIONS COMPLETELY BEFORE
BEGINNING INSTALLATION. FAILURE TO FOLLOW
THEM COULD CAUSE A FIREPLACE MALFUNCTION
RESULTING IN SERIOUS INJURY AND/OR PROPERTY
DAMAGE.
!
WARNING
All electric fi replaces have hot and arcing or sparking parts
inside. Do not use it in areas where gasoline, paint or fl ammable
liquids are present.
This electric fi replace is tested and listed for use only with
the optional accessories listed in these instructions. Use of
optional accessories not specifi cally tested for this electric
fi replace could void the fi replace warranty and/or result in
a safety hazard.
This electric fi replace meets the construction and safety
standards of H.U.D. for application in manufactured homes
when installed according to theses instructions.
1. Prior to plugging your fi replace into an electrical outlet,
verify that the house circuit breakers for the outlet are
on.
2. The fi replace may emit a slight, harmless odour when
fi rst used. This odour is normal and it is caused by the ini-
tial heating of internal fi replace elements and will not occur
again.
3. If your fi replace does not emit heat, consult the operation
section of this manual for further information.
4. Use with a CSA or UL certifi ed surge protector.
CAUTION
Risk of electric shock
Do not open
No user-serviceable parts inside
high temperature
keep electrical cords
Keep drapery and other furnishings at least 3 feet (0.9m) from
the front and sides of the fi replace.
!
WARNING
CAUTION
High temperature, risk of fi re. Keep electrical cords, dra-
pery, furnishings, and other combustibles at least 3 feet
(0.9m) from the front of the fi replace and away from sides
and rear.
Servicing should be done only while the fi replace is discon-
nected from the power supply circuit.
IMPORTANT INSTRUCTIONS