Protecting Yourself While at Home
1 Before arming your system, make sure the Green Ready light is ON. This indicates that all of your
protective zones are secure. If any zones are open, the corresponding Zone light will be ON. Secure
those zones before proceeding.
2 Enter your user code. The Green Ready light will go out, and the Red Armed light will light.
3 Before your exit delay expires, press C to bypass any interior zones, deactivating devices such
as motion sensors, and allowing free movement throughout the premises. The Zone light of any
bypassed zones will flash slowly.
• Your system may have been programmed for Automatic Interior Bypass , in which case it will recognize
that you have not left the premises and will automatically bypass any interior zones.
Instant Mode
Pressing A followed by 4 will cancel the Entry delay , activating the “Instant” mode. This is typically
done in the evening when all family members are home for the night. Instant Mode can be activated at
any time after the system has been armed. The Red Armed light will flash rapidly while in the Instant Mode.
Easy Exit (optional)
Your System may have been programmed to allow Easy Exit, which allows a user to exit the premises
with the system armed. By pressing Bfollowed by 0, the protection is removed from the Exit/ Entry
zone for 3 minutes. This will allow, for example, an early morning commuter to exit the house in the
morning, without having to disarm and rearm the system, waking the family.
Arming With a System Trouble Present (the üü System Light is Lit)
If the XP600 has a system trouble present, the üüSYSTEM light will be lit and the keypad sounder
pulsing. If you cannot immediately clear the system trouble, the system can still be armed. Simply
press C to view the trouble, press C again to reset the trouble and then arm the system.
Arming Your System
6
FIRE
AC
SYSTEM
READY
ZONE 3
ZONE 1
ZONE 2
ZONE 5
ZONE 6
ZONE 4
ARMED
Oi218a.pub
page 6
Thursday, December 18, 1997 18:29