Filter
Top Products
2
Congratulations on your purchase of a
new Freedom Garage Door Security Sys-
tem. This revolutionary new concept in
residential security makes using your
system easier than ever before possible,
because the system uses its computerized
control panel to continually monitor the
status of your garage door. It actually
anticipates what command it should ex-
pect from you next--simply requiring just
one button to press to effortlessly operate
your security system, whether you’re go-
ing, returning or staying in for the night.
Now everyone in your family, young and
old alike, will enjoy the true peace-of-
mind you would expect from a quality,
state-of-the-art NAPCO Security System,
without the fuss of remembering confus-
ing numerical codes to operate it.
Simplicity and convenience begin with
your System’s one-touch STAY or AWAY
buttons, then just open or close the ga-
rage door as usual! Day in and day out,
that’s all there is to it.
This booklet contains important in-
formation about the operation of your
NAPCO Freedom Security System.
Please read it through and retain it for
handy reference. Because your system
is customized for your home and lifestyle,
you may find subjects mentioned here,
that do not apply to your system. Rest
assured your security system has been
configured by your Security Professional
to best suit you and the system itself has
been meticulously designed and engi-
neered to the highest industry standards.
Please test your system at least once a
week as described below.
INTRODUCTION
1 Test your siren and central station communicator:
Hold Down the BYPASS button for 4 seconds (until the
Touchpad beeps). The system will generate a test
report to central station and two momentary chirps of
the siren.
• If the siren does not sound or sounds week, call for service.
• If the system indicates a low battery system trouble (trouble light TBL
flashing 2 times), call for service.
• If the system indicates a communication failure system trouble (TBL
flashing 3 times), call for service. (The communication failure system
trouble may take a few minutes to appear.)
A subsequent press of the SILENCE button will silence the trouble indica-
tion.
2 Test your motion sensors and other protective devices:
Hold Down the BYPASS button for 8 seconds (until the second hold-down
beep).
• Walk through the areas protected by motion sensors. The Touchpad will
beep when the zone is violated and again when the zone is restored.
• Open and close all protected doors and windows and listen for the cor-
responding Touchpad beeps.
After testing the protective devices, the Touchpad ARMED indicator will
flash out the zone number of all zones which have been activated.
Press the SILENCE button to clear the display and end the test.
If any devices fail to respond when activated or register on the Touchpad
display as described above, call for service.
IMPORTANT - TEST YOUR SYSTEM WEEKLY
From a Ready Condition (Disarmed State)
F-TPG_OI309.06_USER_anch...
page 2
Friday, October 28, 2005 15:16
Composite