Filter
Top Products
Arming Your System When Leaving
1
Before armin
g
your system, make sure the
g
reen
Status
li
g
ht is ON. This indicates that all of your protective zones are
secure. If any zones are open, the correspondin
g
Zone number will be lit. Secure these zones before proceedin
g
. If any
zones cannot be secured, see Bypassin
g
zones below.
2
Enter your user code and press
.
The
g
reen
Status
li
g
ht will
g
o out, the red
Armed
li
g
ht will li
g
ht.
•
If you make a mistake enterin
g
your code, press , re-enter the code and press
.
3
Leave the premises throu
g
h the Exit/Entry door. If the keypad
g
ives a steady tone you have taken too lon
g
. Enter your code
a
g
ain to disarm system and then re-enter code and leave.
Easy Arm
The optional Easy Arm feature allows the system to be armed by simply pressin
g
.
This will allow the easy armin
g
of the system by someone who is not a re
g
ular system user.
Bypassing Zones
If an open zone cannot be immediately fixed it can be left unprotected, or
bypassed
,while the rest of the system is Armed.
To bypass a zone:
1
Press followed by the number of the zone to be bypassed. The bypassed zone’s number will flash slowly.
2
Enter your user code and press
.
The
g
reen
Status
li
g
ht will
g
o out and the red
Armed
li
g
ht will li
g
ht.
3
Leave the premises throu
g
h the Exit/Entry door.
When the system is subsequently disarmed, all bypassed zones will be reset, ready to be armed a
g
ain. If it is necessary to
bypass any inoperative zone(s), it is important to have the zone(s) repaired as soon as possible.
A bypassed zone does not provide any protection, compromising system security.
Arming Your System
6
Oi230a
page 6
Tuesday, September 16, 1997 08:26