Filter
Top Products
7
K
NL
M
˜
¯
fi
Removing the floor nozzle
cover
KL
1 Disconnect the cleaner from the mains
supply.
2 Place the cleaner upside down in the flat
position.
3 Use a cross-head screwdriver to remove
the two screws at the front and the
central screw under the height
adjustment mechanism K.
4 Turn the cleaner over and remove the
carpet height adjustment knob fi.
5 Remove the two screws at the rear and
lift the rear of the cover over the handle
release button and unclip the cover from
the front of the floor nozzle L.
Replacing the belt
MN
6 If the belt has broken, ensure all pieces
are removed.
7 Lift off the belt cover ˜.
8 Grasp the brush bar ¯ at both ends and
lift straight up.
9 Place one end of the new belt over the
metal motor shaft pin and the other
around the pulley end of the brush N.
10 Align brush end plates with their guide
slots and push the brush bar down into
place.
11 Re-fit the belt cover.
12 Re-fit the floor nozzle cover. Push the
carpet height adjustment knob back on.
13 Replace the two screws on the top of the
floor nozzle cover and the three screws
underneath the floor nozzle - do not
overtighten.
Safety cut-out
If the cleaner overheats a motor
protection thermostat will automatically
switch the motor off. If this happens, switch
the cleaner off, unplug from the power
supply and leave the cleaner to cool for at
least 30 minutes. Check the airways for
blockages and clean the filters before
restarting.
Helpline
If you have any difficulty with your
appliance, do not hesitate to call us. We’re
more likely able to help than the store from
where you bought the product.
Please have the following information
ready to enable our staff to deal with your
query quickly:
•Name of the product
• Model number as shown on the
underside of the appliance.
8537 Upright Currys cyclone ib 12/05/2003 18:13 Page 7