Filter
Top Products
Install 4 Max. 25 watt candelabra
base bulbs into the sockets on top of
the fan as shown.
Push yoke cover down.
Align hole in downrod with hole in
yoke and install cross pin.
Install cotter pin into cross pin.
Attach blade brackets to blades using the
blade bracket screws and washers provid-
ed.
7
8
10
11
12
Tighten the 2 set screws on the yoke
once the downrod is in place. Then
tighten locking nut.
9
For Canadian installation in both flush and downrod
mode the safety cable must be installed into the
house structure beams using the 3” lag screws pro-
vided. Make sure that when the safety cable is
fully extended the leadwires are longer than the
cable and no stress is placed on the leadwires.
16
Canadian mounting only
Canadian mounting only
Safety Cable
Lag Screw
Install upper glass to top of fan.
13
Install 3 screws and clips to hold
glass to fan housing.
14
Mounting bracket slides open and
shut by turning fan after hanging.
15
After sliding bracket shut place the 2
screws in screw holes and turn only
a few rounds to hold in place. Make
sure you put the canopy on downrod
before you hang fan.
17
screw holes
screw
Place canopy over ball and downrod.
18