Filter
Top Products
–20–
10
Press the PROGRAM button or SET button.
When the PROGRAM button is pressed, the setting is sent to the air conditioner.
Since it takes 3 seconds for transmission, point the remote control at the remote control
signal receiver of the indoor unit during the period.
When the setting is received, a buzzer sound (pip, pip, pip) is emitted.
When the SET button is pressed, the setting continues from Step 2.
9
Press the SET button.
The time is determined and and blink.
8
Set required operation contents.
When ON-TIMER is selected, operation mode, fan speed, and air flow direction can be
changed and the ECONO, SILENT or NIGHT SETBACK operation can be set.
7
Press the “ or (TIMER)” button.
Set a time.
Every time the
button is pressed, the display is switched in the
order of:
0:00 0:10 0:20
...
(Units of ten minutes)
1:00 1:10
Every time the button is pressed, the display is switched in the
order of:
0:00 23:50 23:40
...
(Units of ten minutes)
23:00 22:50
When ON-TIMER is selected, go to Step 8.
When OFF-TIMER is selected, go to Step 9.
Setting mode <Collective setting>
■ Set the same operation contents to the same program number of all the days of the week. In Step 2 above, select “all of the days of the
week”. When the contents that were individually set exist in the same program number, the contents are overwritten.
• If no operation is performed for 60 seconds in setting mode, the setting changes that have been made until then become invalid
and the setting mode terminates. Subsequently,
and all the program numbers (P1, P2, P3 and P4) blink for 10 seconds.
(This blinking can not be observed if setting mode gets terminated while setting only one program.)
• At the end of the setting mode, point the remote control at the air conditioner and press the PROGRAM button. In this case, check
that the air conditioner emits a reception buzzer sound three times (pip, pip, pip). If the buzzer sound is not emitted, set the mode
to the setting mode again by pressing the PROGRAM button and check that the buzzer sound is emitted.
NOTE
RKY012A012B_EN_001-032 4/18/14, 16:4920