Filter
Top Products
–11–
AUTO mode operation
■
Automatically selects the operation mode (COOL, HEAT, DRY) depending on the room temperature when switched on.
• If you do not want the AUTO mode program, change
to COOL, HEAT, DRY or FAN instead of AUTO.
Page 13
• Airflow direction adjustment procedure.
Page 14
AUTO mode can be
operated by simply
pressing the ON/
OFF button.
To stop: Press the ON/OFF button.
When the unit is not in AUTO mode:
Press MODE button.
The mode changes whenever the button is pressed.
Set to
.
Point the remote control toward the air-conditioner, and
Press the ON/OFF button.
1
2
NOTE
Display in OFF status
• The current time, day of the week,
and present OPERATING MODE
are displayed while the air condi-
tioner is turned off.
• In case air is not blowing out
during the operation.
Page 29
• When the included clean filter is
installed the air conditioner will
clean the air during automatic
operation.
Current time setting
■ When inserting the batteries, the current time is automatically set to time setting mode. Mon and 13:00 are displayed as the current
time. Set a correct day of the week and a time.
NOTE
2
Example: Set to Sat 10:30.
Press the TIME SET UP switch.
Press with the tip of a ballpoint pen, etc.
The day of the week display blinks, enabling the setting of a day of the
week.
Press the “ or (TIMER)” button.
(Set to Sat)
Press the SET button.
The day of the week display changes from blinking to steady lighting,
completing the setting of a day of the week, and the time display blinks.
Make sure to press the button within 60 seconds from the last operation in
step 2, otherwise the day of the week is not set.
Press the “ or (TIMER)” button.
(Set to 10:30)
Press the SET button.
The time display changes from blinking to steady lighting and the setting
is complete.
Make sure to press the button within 60 seconds from the last operation in
step 4, otherwise the time is not set.
• The timer operation works based on the time clock, so please
set it correctly.
• The remote control data is reset when the present time is set.
1
3
4
5
• When the battery of the remote control is replaced or the ACL
switch is pressed, the remote control is set to the initial state.
Since the WEEKLY TIMER program is not set in the initial
state, set the program according to the setting procedure.
RKY012A012B_EN_001-032 4/18/14, 16:4911