Filter
Top Products
36
Minimum 3 minutes 2
ON
Thermostat
Indoor fan
Auto vane
Booster heater
Compressor
Power ON lamp
STAND BY lamp
ON
ON
LOW or HIGHLOW or HIGH
ON
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
Extra LOW 1Extra LOW 1
Hot adjustment
10¡
Close
10¡ Close
From POWER ON until
warm begins to blow
Hot adjustment
Depends on remote
controller setting
Depends on remote
controller setting
1 Changeable by indoor
dipswitch J1 - 7 and
J1 - 8.
OFF during thermostat OFF
hot adjustment
defrosting
LOW
Operation starts by
POWER button
ON.
Operation stops by
POWER button
OFF.
The room temperature
displayed on remote con-
troller becomes equal to
set temperature.
The room temperature
displayed on remote con-
troller falls below set
tem-
w
ww
w
w2 Even if the room temperature displayed on remote controller rise above the set temperature during this period, the compressor will not start until this period has
ended.
<HEAT operation time chart>
2-3 HEAT operation
<How to operate>
1 Press POWER ON/OFF button.
2 Press HEAT button to set operation mode to HEAT.
3 To set desired temperature, press WARMER or COOLER
button.
<Display in HEAT operate>
"STAND BY" is displayed from HEAT operation start until warm
air begins to blow.
"DEFROST" is displayed during defrosting.
MITSUBISHI ELECTRIC
-CENTRALLY CONTROLLED-
STAND BY
DEFROST
ON
CHECK DRY
COOL
HEAT
CHECK
SET TEMP
TIMER OFF
AUTO STOP
AUTO START
F
HR
F
LOW HIGH
AUTO RETURN
CHECK TEST RUN
POWER
ON/OFF
HEAT
SET
TEMPERATURE
AUTO COOL/DRY
COOLERWARMER
TIMER MODE HOURS
FAN SPEED LOW/HIOGH
AIR
DISCHARGE
UP/DOWN
SWING
STOP
CHECK TEST RUN
OC120--2.qxp 24/6/97 12:31 AM Page 36