Mitsubishi Electronics PCFY-P30NKMU-E Heat Pump User Manual


 
OPERATING PROCEDURE
PHOTOS & ILLUSTRATIONS
31
Screw
Side panel
(Right)
Side panel
(Left)
Sliding the panel
to the front
Figure 3
6. Removing the side panel
(1) Remove the air intake grille. (See Figure 1,2)
(2) Remove the screw from the side panel, and remove the
side panel by sliding the panel to the front.
5. Removing the fan (3 connection)
(1) Remove the air intake grille. (See Figure 1,2)
(2) Remove the screw from the beam and remove the beam.
(See Photo 1)
(3) Remove 2 screws from the electrical cover, and remove
the electrical cover.
(4) Remove 2 screws from the electrical box and pull the
electrical box downward.
Temporarily secure the electrical box using 2 hooks in
the back of electrical box.
(5) Remove 2 screws from the left side beam and remove
the beam. (See Photo 9)
(6) Loosen 2 set screws (2 hexagon set screws) of connect-
ing joint. (See Photo 5)
(7) Remove 3 lower casings while pressing each 4 catches
of the casing. (See Photo 6)
(8) Remove the 4 screws from the bearing support. (See
Photo 10)
(9) Slide the connecting joint to the left and remove the fans
and shaft together. (See Photo 11)
(
10
) Remove the fan from the shaft. (See Photo 7,8 )
Photo 9
Beam
Photo 10
Bearing sup-
port fixing
screws
Bearing support
Shaft
Photo 11
Fan (3 connection)
Bearing support
Shaft