Filter
Top Products
5
■ Wireless Remote-Controller
■ Outdoor unit
Power
Earth
Service Panel
Indoor-Outdoor
Connection wire
Ref. Pipes
2. Parts Names
ON/OFF button
Fan Speed button (Changes fan speed)
Test Run button
Remote controller display
Airflow button (Changes up/down airflow direction)
Louver button (Changes left/right airflow direction)
Set Temperature buttons
Mode button (Changes operation mode)
Set Time button (Sets the time)
Timer Off button
Timer On button
Transmission area
Transmission indicator
Timer indicator
Operation areas
Hour button
Minute button
Reset button
Check button
■ When using the wireless remote controller, point it towards the receiver on the indoor unit.
■ If the remote controller is operated within approximately two minutes after power is supplied
to the indoor unit, the indoor unit may beep twice as the unit is performing the initial auto-
matic check.
■ The indoor unit beeps to confirm that the signal transmitted from the remote controller has
been received. Signals can be received up to approximately 7 meters in a direct line from
the indoor unit in an area 45° to the left and right of the unit. However, illumination such as
fluorescent lights and strong light can affect the ability of the indoor unit to receive signals.
■ If the operation lamp near the receiver on the indoor unit is flashing, the unit needs to be
inspected. Consult your dealer for service.
■ Handle the remote controller carefully! Do not drop the remote controller or subject it to
strong shocks. In addition, do not get the remote controller wet or leave it in a location with
high humidity.
■ To avoid misplacing the remote controller, install the holder included with the remote con-
troller on a wall and be sure to always place the remote controller in the holder after use.
Battery installation/replacement
1. Remove the top cover, insert two AAA batter-
ies, and then install the top cover.
1
2
3
2. Press the Reset button.
Top cover
Two AAA batteries
Insert the negative (–)
end of each battery
first. Install the batter-
ies in the correct direc-
tions (+, –)!
Press the Reset button
with an object that has
a narrow end.
* For explanation purposes, all of the items
that appear in the display are shown.
* All items are displayed when the Reset
button is pressed.
BG79U794H02_en 05.12.22, 2:01 PM5