Filter
Top Products
19
9.1 MS-GD08ND-
C1
MS-GD10ND-
C1
MS-GD12ND-
C1
OPERATING PROCEDURE PHOTOS
Photo 1
Screws of the panel
1. Removing the panel
(1) Remove the screw caps of the panel.
Remove the screws.
(2) Pull the panel down to your side slightly and unhook the
catches at the top.
2. Removing the electronic control P.C. board and the
power monitor, receiver P.C. board
NOTE : In case of removing only indoor electronic control
P.C. board work (3) is not necessary.
(1) Remove the panel. (Refer to 1.)
(2) Remove the power monitor, receiver P.C. board
holder from the bottom of electrical box.
(3) Open the power monitor, receiver P.C. board holder and
remove the power monitor, receiver P.C. board.
(4) Remove the screw of the electrical cover and the electrical
cover.
(5) Remove the screw of the V.A. clamp and the V.A. clamp.
(6) Remove the screw of the cord clamp and the cord clamp.
(7) Remove the screw of the terminal block.
(8) Remove the screw of the ground wire.
(9) Pull out indoor electronic control P.C. board slightly.
(10)
Disconnect all (except CN125, CN109) the connectors on
the electronic control P.C. board.
(11)
Remove the electronic control P.C. board.
(12)
Disconnect the connector of power monitor, receiver P.C.
board (CN 125, CN109) on the electronic control P.C.
board.
Terminal block
fixing screw
Screw of the V.A.
clamp
Indoor electronic
control P.C. board
Screw of the
ground wire
Power monitor, receiver
P.C. board holder
Screw of the
electrical cover
Photo 2
DISASSEMBLY INSTRUCTIONS9
<”Terminal with locking mechanism” Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the locking
mechanism.
Sleeve
Locking lever
1 Slide the sleeve.
2 Pull
the terminal
while pushing
the locking lever.
1 Hold
the sleeve, and
pull out the terminal
slowly.
Connector
INDOOR UNIT