Melissa 240-114 Vacuum Cleaner User Manual


  Open as PDF
of 23
 
14
15
Assembly before use:
• Beforeusingtheappliance,checkthatthelter
pad(3)andthelterholder(21)havebeencorrectly
ttedtothelterhousing(2)(see“Cleaningand
replacementoflter”).
• Attach the battery to the back of the handle (9).
Ensure that the lock buttons (11) click into place, so
that the battery is securely attached.
USE
• Push the on/off button (7) forward to switch on the
appliance and backward to switch it off.
• The nozzles can be attached to the nozzle tip (1) as
required:
o The crevice nozzle/the extension (12) must be
attached so that the lock tab (13) is facing down.
o When using the small brush nozzle (15) and the
crevicenozzle(16),rstattachthecrevice
nozzle/the extension.
o Ensure that the lock tab on the extension clicks
into place in the lock holes (14) of the small
nozzles.
• This appliance is specially designed to vacuum up
liquids.
o Use the special nozzle for liquids (18) to vacuum
up liquids.
o Ensure that the nozzle for liquids is attached so
that the arrow marked “TOP” is facing up on the
nozzle tip.
o The amount of liquid vacuumed up must never
exceedthemark“MAX.”(20)onthelter
housing.
o Hold the appliance in a slightly downward angle
toensuretheliquidstaysinthelterhousing,
until it is emptied.
o IMPORTANT! Should the liquid exceed the mark
“MAX.”orinanywaytouchthelter,immediately
switchofftheappliance,emptythelterhousing
andclean/drythelterpad(see“Cleaningand
replacementoflter”below).
• Toemptythelterhousingfordustorliquids,press
theopeningbutton(4)andcarefullydetachthelter
housing.Pulloutthelterandthelterholderfrom
thelterhousing,andemptyit.Cleanthelterpad,
before reattaching it (see “Cleaning and replacement
oflter”below).
• Adjust the angle of the appliance by pressing the
release button (8) and tilting the motor section and
thelterhousingtotherequiredpositions.
• If the appliance loses suction power during use, the
battery needs to be recharged.
• Lack of suction power may also be caused by
thelterbeingblockedandneedingcleaning(see
“Cleaningandreplacementoflter”below)
• If the appliance still does not have full suction power
aftercleaningorreplacingthelterpad,thenozzle
tip or the nozzle may be blocked.
• NOTE: Check cause of fault and correct. Do not use
appliance if any air holes are blocked. Permanent
motor damage can result.
Tips for vacuum cleaning
• At the back of the appliance there are some small
rubber knobs to ensure the appliance stands
securely in a vertical position.
• Each nozzle has a special purpose. Try out e.g. the
crevice nozzle, the extended nozzle (12+16) or the
smallbrushnozzleindifferentsituationstondyour
own preferences.
• The nozzle for liquids is ONLY suitable for
vacuuming liquid – when using the appliance for this
purposethisnozzlemustALWAYSbetted.
Storage
• Store in a cool dry place. Do not place heavy
objects on top of the appliance.
• NOTE: Remove the batteries from the handle if the
appliance is to be stored for an extended period.
CLEANING AND REPLACEMENT OF FILTER
IMPORTANT! If the appliance loses suction power
duringuse,thelterpadmaybedirty,andneeds
cleaning or replacing. Never use the appliance, when
thelterisdirtyorwhenithasnotbeentted.
1. Press the opening button and carefully detach the
lterhousing.
2. Pulloutthelterpadandthelterholderfromthe
lterhousing.
3. Pulloutthelterpadfromthelterholderandclean
it according to the following directions:
oShakeandbeatthelterpadcarefullytoremove
dust and dirt.
oThelterpadcanbewashedcarefullyinwarm
water.
oCheckthelterpadiscompletelydrybefore
replacing in the appliance. NEVER insert a wet
lterintotheappliance.
1. Insertthelterpadinthelterholder,andmake
surethelterpadisfullyinserted.
2. Pressthelterholderasfarintothelterhousing
asitwillgo.Thelterholdermustrestonthefour
dowelsontheinsideofthelterhousingsothatitis
sealed all the way round.
3. Attachthelterhousingtothemotorsectionsothat
theopeningbuttongripsthelterhousingandholds
it in place.
4. Whenthelterpadsarewornorcannotbeproperly
cleaned, replace them with pads of the same type.
Cleaning of the appliance
• Clean the appliance by wiping it with a cloth wrung
in tepid water. A little detergent can be added if the
appliance is heavily soiled.
• Do not use scouring pads or any form of strong
solvents or abrasive cleaning agents as they could
damage the outside of the appliance.
 previous next