Filter
Top Products
ENGLISH
|
7
CONNECTING UTILITY BRUSHES
NOTE: Both Nylon Utility Brushes and the Brass Utility Brush are all attached in the same
manner.
1. Begin by aligning hexagonal-shaped hole on back of Utility Brush (FIGURE 3-A) with hexagonal
tip of Jet Nozzle (FIGURE 3-B).
2. Firmly press Utility Brush onto tip of Jet Nozzle (FIGURE 3-C).
CAUTION: Make sure Utility Brush is pushed as far as possible onto tip to ensure that it
is seated securely. This will prevent steam leaks and ensure that Utility Brush is not
forced off of Jet Nozzle by steam pressure.
3. To remove Utility Brush, simply grasp and rmly pull until it disconnects from Jet Nozzle.
CAUTION: Make sure unit is unplugged and has had sufcient time to cool down before
attempting to remove any accessories.
FIGURE 3
3-A
3-B
3-C