Filter
Top Products
12
|
ENGLISH
Troubleshooting
Unit fails to heat up and begin
steaming. Heating Indicator Light
DOES NOT illuminate.
Unit fails to heat up and begin
steaming. Heating Indicator Light
DOES illuminate.
NOTE: Always allow sufcient
time for unit to heat up and begin
producing steam.
Steam output is weak or intermittent.
Boiler Cap cannot be unscrewed.
Jet Nozzle / Wide Nozzle cannot be
removed.
Unit is not plugged in.
No water in Boiler.
Mineral build-up in unit.
Mineral build-up in unit.
Household circuit breaker / ground
fault interrupter has tripped or blown
a fuse.
Unit is damaged or otherwise in
need of repair.
Unit is damaged or otherwise in
need of repair.
Water level in Boiler is running low.
Boiler Cap has been overtightened
after previous use.
Attempting to disconnect accessory
at the wrong point.
Plug power cord into electrical outlet.
Refer to Mineral Build-up section on
Page 11 for cleaning procedure.
Refer to Mineral Build-up section on
Page 11 for cleaning procedure.
Reset circuit breaker / ground fault
interrupter, or replace fuse. For
assistance, contact a licensed electrician.
Immediately cease usage and unplug.
Contact Consumer Service for
assistance (see Page 13 for details).
Immediately cease usage and unplug.
Contact Consumer Service for
assistance (see Page 13 for details).
Refer to Filling With Water procedure
on Page 9 to rell unit with water.
Boiler Cap should always be replaced
loosely when storing. For assistance
with a Cap that has become stuck,
contact Consumer Service (see Page
13 for details).
Check to be certain that you are
attempting to remove the accessory
only (gray), and not the Steam
Aperture as well (yellow).
Refer to Filling With Water procedure
on Page 9 to ll unit with water.
PROBLEM POSSIBLE CAUSE SOLUTION