Filter
Top Products
ASSEMBLING THE
HEAVY-DUTY STEAM CLEANER
710
USING THE
HEAVY-DUTY STEAM CLEANER
OPERATING HEAVY-DUTY STEAM CLEANER
NOTE: Be sure that Water Reservoir has already been filled and that all desired
accessories are connected before following these steps.
1. Plug grounded power cord into a convenient electrical outlet.
CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in
properly installed 3-prong electrical outlets. Do not attempt to alter plug or
circumvent this safety feature in any way.
2. Switch Lighted On/Off Switch to “On” position. Steam Ready Light will immediately
illuminate.
NOTE: Steam Ready Light is illuminated while boiler is heating.
3. Steam Ready Light will deactivate in 2-8 minutes (depending on how much water is in
Water Reservoir), indicating that boiler is heated and unit is ready to begin steaming.
4. Direct Steam Jet Nozzle (or other accessories) towards surface you desire to steam, and
press Steam Button. To sanitize surfaces, point Steam Jet Nozzle, press Steam Button
and hold approximately 1/2 inch from surface for at least 5 seconds. This will insure
that you have killed germs and bacteria.
CAUTION: Always be sure that Steam Jet Nozzle and other accessories are
pointed in a safe direction (away from yourself, other people, pets, and plants)
before pressing Steam Button.
5. Keep Steam Button depressed for a continuous flow of steam. You may also slide the
Steam Lock Switch forward while depressing the Steam Button to lock the Steam
Button down. This will let you have a continuous flow of steam without having to hold
down the Steam Button.
6. Using a slight back-and-forth motion over the area you are steaming will further
enhance the cleaning process. Wipe steamed areas with a clean cloth to remove
loosened dirt and grime. Wiping the area while it is still wet is recommended, but use
caution when wiping surfaces such as metal that may still be hot.
NOTE: During use, the Steam Ready Light may illuminate. This is normal. If you
notice a drop in steam pressure, release Steam Button until Steam Ready Light
deactivates once again.
7. Once steaming tasks are complete, immediately set Lighted On/Off Switch to “Off”
position and unplug grounded power cord from electrical outlet. Follow steps under
Proper Storage procedure on page 11 of this manual.
ATTACHING CARRY HANDLE
1. Insert Carry Handle into Carry Handle hole
on top of unit. Please refer to illustration
for assistance with proper alignment
(FIGURE 1).
2. Use enclosed magnetic screw driver and
screw to securely fasten Carry Handle to
unit.
ATTACHING MAIN ACCESSORIES
WARNING: Do not try to connect accessories while unit is emitting steam.
This section applies to the Steam Jet Nozzle, Squeegee, Floor Brush, Extension
Wands and Triangle Brush.
1. Depress red lock/release button on main steam nozzle (FIGURE 2-A).
2. While still depressing lock/release button, slide Steam Jet Nozzle or other accessory
over this button, so that rectangular hole in attachment aligns with lock/release button
(FIGURE 2-B).
3. Once lock/release button and rectangular hole are properly aligned, button should click
through hole and into place.
4. To remove Steam Jet Nozzle or other accessory, press in red lock/release button and
pull attachment off of main steam nozzle.
FIGURE 2
FIGURE 1