Filter
Top Products
HEAVY-DUTY STEAM CLEANER
PRODUCT INFORMATION
5
The following features and accessories are included with your Heavy-Duty Steam Cleaner.
Carefully inspect packaging material as some parts are shipped inside Styrofoam packaging.
UNIT FEATURES &ACCESSORIES
1. LIGHTED ON/OFF SWITCH
2. STEAM READY LIGHT
3. STORAGE COMPARTMENT
4. WATER RESERVOIR
5. HANDLE
6. STEAM LOCK SWITCH
7. STEAM BUTTON
8. CARRY HANDLE
9. STEAM JET NOZZLE
10. STEAM HOSE
11. FLOOR BRUSH
12. SQUEEGEE
13. EXTENSION WANDS
14. WATER FUNNEL
15. MEASURING CUP
16. CLOTH TOWEL
17. TRIANGLE BRUSH
18. ASSORTED UTILITY BRUSHES
19. BRASS UTILITY BRUSH
20. SCRUB PAD
12
TROUBLESHOOTING
PROBLEM
Unit fails to steam. Lighted
On/Off Switch does not
illuminate.
Unit is not plugged in.
Plug into electrical outlet.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse.
Reset Circuit Breaker / Ground
Fault Interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Unit fails to steam. Lighted
On/Off Switch does illuminate.
Water Reservoir is empty. Refill Water Reservoir using
procedures on page 9 of this
manual.
Mineral build-up in unit.
Follow Removing Mineral
Build-Up procedure on page 11
of this manual.
Steam output is intermittent.
Mineral build-up in unit.
It is normal for unit to
periodically stop steaming for a
few seconds. If steam stays off
for longer periods, follow
Removing Mineral Build-Up
procedure on page 11 of this
manual.
Unit is emitting excess water. Water condensation in Steam
Hose.
Point main steam nozzle towards
sink, tub or ground and shake
while depressing Steam Button.
Continue until excess water is
released.
POSSIBLE CAUSE SOLUTION
Water Reservoir has been
over-filled.
Point main steam nozzle towards
sink, tub or ground and shake
while depressing Steam Button to
remove water that may have
condensed in Steam Hose.
Empty some water out of Water
Reservoir.
Unit has not reached operating
temperature.
Wait until Steam Ready Light
deactivates to steam.