Filter
Top Products
Instructions for Installation (cont'd)
Converting the Lower Element
(cont'd)
7. The wire removed from terminal 2 has a looped end. It 11. Replace the access panel.
must remain looped and now be placed (as shown) on top
of the buss bar, over the opening of terminal 2, and secured _1[ _ _
using the remaining screw. _ _ i
8. Tighten terminals 2 and 3 to ensure proper electrical con-
nection. 12. Complete wiring to the water heater, or if completed, turn
"ON" elech'ic power to the water heater after filling the
_WARNING tank with water,
Failure to tighten terminal screws can cause a fire I
which can result in DEATH. SERIOUS BODILY INJURY,
OR PROPERTYDAMAGE.
9. Replace terminal cover on thermostat and fold insulation
back over the element making sure that the locking tabs on
the terminal cover are in place.
AWARNING
Make sure the thermostat is flush against the tank, I
the terminal cover is in place, and the insulation isI
replaced. Failure to do so can result in DEATH, SERI-
OUS BOD LY NJURY,OR PROPERTYDAMAGE.
_, CAUTION J
10. Fold the insulation back in place so that it completely coy- Never use this water heater unless it is completely I
ers the thermostat and element, full of water. To prevent damage to the tank and I
heating element, the tank must be filled with water, [
Water must flow from the hot water faucet before
turning "ON" power.
14