Marquis DVT-38 Indoor Fireplace User Manual


 
Marquis 38 19
Set the thermostat, if present, to the lowest level. Press slightly and turn the control knob
clockwise 3 to the OFF position and wait 5 minutes; thus allowing any gases to escape
which may have accumulated in the combustion chamber.
Note: LP gases do not vent upward. Then follow step 2 and 3 to establish pilot.
INITIAL START UP INSTRUCTIONS Cont..
Press and turn control knob counterclockwise 4 to ON position.
Release control knob. If pilot should go out, turn the control knob to OFF position and
repeat steps 1, 2 and 3.
Note: this will allow reset of INTERLOCK for proper lighting of pilot.
Press slightly and turn control knob counterclockwise 4 to PILOT position; depress
control knob and light pilot by repeatedly pressing the sparker. Venting of air may take
place at the pilot prior to the flow of fuel gases. Once flame is established, hold knob
depressed for approximately 60 sec.
START-UP PROCEDURE
1.
2.
3.
4.
5.
6.
Turn thermostat to the desired comfort level or turn ON/OFF switch to the ON position.
7.
TEMPORARY SHUT-DOWN PROCEDURE
To turn off the main burner only, set the thermostat to the lowest setting or turn remote
switch to OFF. Press and turn the control knob clockwise
3 to PILOT position.
Press and turn the control knob clockwise 3 to the OFF position.
COMPLETE SHUT-DOWN PROCEDURE
Control Knob