Filter
Top Products
NOTE: The Setback settings need to be performed in a timely manner, as the
thermostat will timeout and automatically exit these adjustment screens after
approximately 10 seconds without a button press.
TO START A SETBACK: Press the MENU button, then press the SCROLL button
until “TEMPERATURE SETBACK” is shown, then press the OK button. The words
“OVERRIDE LEFT” will appear at the top of the screen, along with two digits and
the word “HRS”. Use the UP and DOWN buttons to set the duration for how long
you would like to maintain a fixed set temperature (from 1 to 12 hours). If you
would like to set the duration for longer than 12 hours, keep pressing the UP
button. The display will change from “HRS” left to “DAYS” left, with an available
duration of 1 to 30 days. Once you have selected your desired Setback duration,
press the NEXT button to advance. The display will change from “OVERRIDE
LEFT” left to “OVERRIDE TEMPERATURE”. Use the UP and DOWN buttons to select
your desired Set Temperature that will be used during the Setback duration.
Once complete, press the NEXT button to accept the setting and return to the
Normal Run screen.
TO CANCEL A SETBACK: A Setback can be cancelled by either pressing the HOLD
button two times, or by moving the mode switch to OFF, pausing briefly, then
switching back to the HEAT or COOL position. When in the Normal Run mode, the
display should say either “HEAT MODE” or “COOL MODE”.
TEMPERATURE LIMIT STOPS: There are two independent set temperature limit
stops: a maximum heat set temperature, and a minimum cool set temperature.
These stops do not prevent a user from performing normal actions like
Temperature Override or Hold. The Heat Limit Stop prevents the set temperature
from being adjusted higher than the heat limit setting. The Cool Limit Stop
prevents the set temperature from being adjusted lower than the cool limit
setting. Each of these temperature stops is user adjustable in one-degree
increments, and these settings are protected by a selectable 2-digit code to
prevent unauthorized tampering. By default, this 2-digit code is “00”, and the
temperature stops can be used as-is with this code.
NOTE: The Temperature Limit Stop settings need to be performed in a timely
manner, as the thermostat will timeout and automatically exit the setting screens
after approximately 10 seconds without a button press.
28