Filter
Top Products
TEMPERATURE CALIBRATION DESCRIPTION: The internal temperature sensor in
this thermostat is accurately calibrated at the factory, and in most cases,
alterations to this setting should not be needed. The Temperature Calibration
feature allows you to manually offset the measured temperature by as much as
plus or minus 5°F (3°C) degrees from its original value. This feature can be
useful to match or synchronize this thermostat to another one or more, if multiple
thermostats are used in the same home.
TO CHANGE THE SWING, OFFSET, AND CALIBRATION: Press the MENU button, then
press the SCROLL button until “SET/REVIEW SWING VALUE” is shown on the
screen, then press the OK button. The words “ADJUST VALUE SWING” will appear
at the top of the screen, along with a single flashing digit. Use the UP and DOWN
buttons to change the number value from #1 to #9. Press the NEXT button to
accept the Swing setting and proceed to the Offset setting.
After the Swing value has been accepted, the words “ADJUST VALUE OFFSET” will
appear at the top of the screen, along with a single flashing temperature digit.
Use the UP and DOWN buttons to change the number value between 0°F and 9°F
degrees (0°C to 5°C). The 0° (zero) degree setting will disable the 2nd heating
stage while in regular Heat mode. Press the NEXT button to accept the Offset
setting and proceed to the Calibration setting.
After the Offset value has been accepted, the words “ADJUST VALUE CAL” will
appear at the top of the screen, along with a single flashing temperature digit.
Use the UP and DOWN buttons to change the number value between –5°F and
+5°F (–3°C and +3°C). The 0° (zero) degree setting is the default value, and will
not alter the displayed room temperature from the measured reading. Press the
NEXT button to accept the Calibration setting and return back to the Swing
setting. You can keep pressing the NEXT button to review your three setting
values, or press the EXIT button to return to the Normal Run screen.
SETBACK FEATURE: The setback feature is similar to both a Temperature
Override and a Temperature Hold, in that both are used to maintain a fixed set
temperature instead of following a programmed daily routine. A Setback can be
considered the same as a Temperature Override, which can last for a longer
duration that you can adjust from 1-12 hours, or 1-30 days. By default, when a
Setback is activated in Heat mode, the set temperature used will be 5F (3C)
degrees lower than the current set temp. For Cool mode, the set temperature
used will be 5F (3C) degrees higher than the current set temp.
27