Filter
Top Products
1. Strip wire insulation leaving only 3/8 in. (9.5mm) bare wire ends, and
clean off any corrosion present.
2. Fill the wall opening with non-combustible insulation to prevent drafts
from affecting the thermostat’s normal operation.
3. Route the wires through the opening in the new thermostat base plate,
and hold the base against the wall. Try to line up the screw holes from
the prior thermostat, and install the mounting screws.
4. If the previous holes cannot be used, hold the thermostat base against
the wall so that it appears straight and level (position the base for best
appearance) and mark for the new screw holes. Attach the base to the
wall using the screws provided (use the supplied plastic anchors if
needed when mounting to a soft material such as drywall).
CONNECTING THE WIRES:
When attaching the wires to the thermostat, please ensure that the bare
wire ends are held ALL the way into the terminal block while the screw is
being tightened.
WIRING BASE PLATE NOTICE:
This thermostat model is part of a family of similar models that have the
same general visual appearance. Even though this base plate may look the
same as base plates from other models, the wiring connections may have
different terminal letters for different purposes. Please do not interchange
the back plates and/or thermostat front halves of other similar looking
models. Doing so may cause undesired heating and/or cooling operation
to occur.
5
WIRING INFORMATION:
INSTALL THERMOSTAT BASE:
THERMOSTAT TOP VIEW