Filter
Top Products
QLR1660 User Manual
22
■ Shutdown button
Click this button to shutdown the main server application.
[NOTE] The default ID and password of administrator are ‘admin’ and ‘master’
■ Relay On buttons
If you click ‘RELAY’ tap, the relay on buttons appear.
- Clicking these buttons will activate the corresponding external relay
outputs.
(Refer to ‘SECTION 3-2-6. Speaker, Relay out Setup’ and ‘Appendix-2.
External Sensor and Relay Installation’.)
■ Pan/Tilt/Zoom
Control buttons
If you click ‘PTZ’ tap, the Pan/Tilt/Zoom control buttons appear.
- The following controls are available:
▪ Camera Selection to control Pan/Tilt/Zoom/Focus
▪ Tilt up/down (▲/▼)
▪ Pan left/right (◄/►)
▪ Zoom in/out (+/-)
▪ Focus in/out (+/-)
▪ Auxiliary (1,2,3)
(Refer to ‘Appendix -1.Pan/Tilt/Zoom Camera Installation’.)
■ Color Control
buttons
Clicking the ‘Color’ tab brings up the picture adjustment controls.
.
- You are able to control the brightness, contrast, hue and saturation of
the video image.
■ Audio Speaker(On/Off)
/ Volume Control
buttons
Use for full-duplex audio communication with the QLR1660 Client system.
- Clicking the speaker button enables you to listen to the sound that is transmitted from the
connected QLR1660 Client.
- Control the volume by moving the volume control button.
[NOTE] For full-duplex audio communication with the QLR1660 Client system,
the amplified microphone has to be connected to QLR1660 card and
an audio that microphone is connected actually has to be enabled at ‘Audio
recording and transferring' in System setup panel.
*Calling Message Window
: If the QLR1660 client tries to audio-communicate using ‘Call’ button (
),
the ‘Calling message’ window is displayed as below.
If you click ‘OK’, the below window is displayed.