Filter
Top Products
36 Optional Equipment
© Travis Industries 100-01164 4041115
Rear Blower Installation (Part # 99000138)
The rear blower improves heat transfer by pushing heated air through the convection channel. Operating
instructions are described in the section "Blower Operation".
1 The stove should be in place with the legs installed prior to installing the rear blower.
2 Follow the directions below to install the blower. Use the
Use the wire clip to insure the wires from the thermodisk are held in place away from the firebox (this
prevents damage to the wires).
Slide the
thermodisk
assembly into
the space
between the
stove and rear
heat shield.
Run both of the
wires from the
thermodisk down
behind the stove
and through the
eye of the wire clip.
Wire Clip
Thermodisk
This portion
hooks on the
top edge of the
rear heat shield.
The two yellow wires
attach to the thermodisk.
Three holes for
attaching the
blower box to the
back of the stove
Power Cord
(exits from back
of blower box)
Blower Box
FRONT
Wire Clip
This portion of the wire
clips slides over the
rear heat shield
The wires pass through the eye of the wire clip.