Linear DVS-1200 Home Security System User Manual


 
7
10 AUXILIARY FUSE
Type 2AG, 1-amp fuse.
Protects the external relay output when used with wet contacts (12 VDC
switched out).
Fuse will blow when load exceeds 1 amp.
WARNING: For continued protection against the risk of fi re, replace only
with the same type and rating of fuse.
11 MAIN TERMINAL BLOCK
Terminals for connection to the plug-in AC transformer.
Terminals for connection to an external siren speaker.
Automation Output to connect to an automation controller.
External relay output for “wet” contacts (switched 12 volts) or “dry” contacts
(normally open 1 amp @ 24 volts maximum).
12 BATTERY FUSE
Type 2AG, 3-amp fuse for the backup battery.
If the POWER light is fl ashing and the optional backup battery is installed and
charged, check this fuse.
WARNING: For continued protection against the risk of fi re, replace only
with the same type and rating of fuse.
13 TELEPHONE TERMINAL BLOCK
Provides telephone connections for the digital communicator.
Provides telephone connection for voice prompted telephone remote control
(optional VB-2 digital voice response module required).
Provides seized ring and tip connections for local telephone instruments.
Communicator will disconnect local telephones while on-line.
14 INTERNAL SPEAKER CONNECTOR
Connects the internal speaker to the Console circuit board.
2-pin connector, non-polarized.
15 ANTENNA TERMINALS
Antenna and ground terminals for receiving signals from the system's sensors.
Pre-wired to the Console's internal wire dipole antenna.
Alternately connects to the Model LA-P local whip and remote antenna kit.
16 OPTIONAL BACKUP BATTERY
Space for 12-volt, 1.2 amp/hour backup battery. (Highly recommended.)
Backup battery is automatically charged and monitored by the Console.
Backup battery can power the Console for up to 6 hours.
UL NOTE: Normal estimated battery life should be 3 to 4 years.
17 WIRING ACCESS HOLE
Provides access to recessed wiring trough in base of Console.
Route cables for power, telephone, external speaker, etc. through this hole.
Loop for zip-tie strain relief provided next to hole.
18 WALL-MOUNT SLOTS
Used when mounting Console recessed in the wall.
Two mounting brackets (supplied) slide through slots and are retained by
screws, clamping the unit to the wall.
19 RADIO TEST POINTS
Used to monitor the Console's radio receiver during troubleshooting.
Provides connection for an audio amplifi er to listen to the receiver's output.
Helpful to determine sources of radio interference.
20 MICROPHONE (WITH MODEL VB-2 INSTALLED ONLY)
High sensitivity microphone.
Detects room audio when communicator is reporting to the Central Station
in 2-way audio mode (Model VB-2 digital voice synthesis module must be
installed).
21 ANNUNCIATOR VOLUME CONTROL
Varies the volume of the advisory tones that come from the speaker.
Does not affect internal or external sirens (they are always full volume).
22 DIGITAL VOICE SYNTHESIS MODULE (OPTIONAL)
The Model VB-2 gives the Consoles's digital communicator listen-only, manual
2-way and full duplex 2-way audio capability with the Central Station.
The module allows remote command of the system using a standard pushbutton
telephone, on or off site.
The module provides optional voice prompts from the Console’s speaker.
Units programmed for two-way duplex can still be controlled manually by
pressing the “1” or “3” key.
The Central Station can now return the unit to two-way duplex by pressing the
“8” key.
10
11
12
22
13
14
21
20
15
16
17
18
19