Filter
Top Products
A-6
INSTALLATION
MAGNUM COOLER 10-I & 20-I
A-6
2. Route all water line connections onto connection block at back of Cooler as outlined in the IM manual
provided with the Magnum Cooler.
Self Tapping Screw
(4 req'd)
W
ARNIN
G
ON COOLERS 20 & 20-I :
Align holes A & B of mounting bracket with holes A & B of Magnum Cooler. Secure bracket to the back
of Cooler with 4 self tapping screws provided.
1. ON COOLERS 10 & 10-I :
Align holes A & C of mounting bracket with holes B & C of Magnum Cooler. Secure bracket to the back
of Cooler with 4 self tapping screws provided.
BRACKET HOLE "A"
BRACKET HOLE "B"
COOLER HOLE "B"
COOLER HOLE "C"
BRACKET HOLE "C"
COOLER HOLE "A"
NOTE: FOR PROPER INSTALLATION WHEN USED WITH LINCOLN K835, K840,
K841 OR K842 UNDERCARRIAGES, THE RUBBER FEET MAY NEED TO BE
REMOVED FROM THE BOTTOM OF THE MOUNTING BRACKET.
Door Bumper
(Factory Installed)
(6 req'd)
SEE NOTE
Mounting Bracket
(shown detatched
from Cooler back
for clarity)
1/2-13 Hex Nut
1/2-13x1.50HHCS
Large Plain Washer
*NOT REQ'D WHEN USING
UNDERCARRIAGE OPTION
Plain Washer
Lock Washer
POWER SOURCE
FRONT
Optional
Undercarriage Arm
FIGURE 3a FIGURE 3b
TABLE 2
Recommended Magnum Cooler Use with Lincoln
Power Source / Undercarriage Combination
Figure 3c
Power Source Cooler Undercarriage Mtg. Bkt.
Scheme
CV-200-I Cooler 10-I K874 A
CV-300-I Cooler 10-I or 20-I** K874 A or C
CV-400-I Cooler 10-I or 20-I** K874 B or D
CV-500-I Cooler 20-I K841-1* E
R3R-375-I Cooler 20-I K841-1* E
R3R-500-I Cooler 20-I K841-1* E
R3R-600-I Cooler 20-I K841-1* E
** Use 20-I model for demanding welding applications.
* Not available at the time of printing.