Filter
Top Products
-32-
Operation
Name and Function-Remote Control
The remote control transmits the signals to the system.
START/STOP BUTTON
Operation starts when this button is pressed and
stops when the button is pressed again.
OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps
low, medium, high and CHAOS.
JET COOL/HEATING
Used to start or stop the speed cooling/heating.
(speed cooling/heating operates super high fan speed
in cooling/heating mode)
CHAOS SWING BUTTON
Used to stop or start louver movement and set the
desired up/down airflow direction.
ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
TIME SETTING BUTTONS
Used to adjust the time.
TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained and to
cancel the Timer operation.
SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating.
ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
RESET BUTTON
Used prior to resetting time or after replacing batteries.
2nd F Button
Used prior to using modes printed in blue at the bottom of buttons.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
AUTO CLEAN
ON
OFF
CANCEL
SET
1
3
5
4
9
10
14
7
2
8
13
11
6
12
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Heating Operation
•
Cooling Model( ), Heat Pump Model( )
Flip-up door
(opened)
Signal transmitter
Operation Mode