Filter
Top Products
ENGLISH
15
Open the front
panel upward
Slide
Switch
Slide Switch
FORCED
OPERATION
AUTO
RESTART
REMOTE
CONTROL
Open the front
panel upward
Slide
Switch
Slide Switch
FORCED
OPERATION
AUTO
RESTART
REMOTE
CONTROL
Slide Switch Operation
FORCED OPERATION
Operation procedures when the remote control can't be
used.
Open the front panel upward and move the Slide
Switch to the Forced Operation position.
If you want to stop operation, move the Slide Switch to
the Auto Restart or the Remote Control position.
In case the power comes on again after power failure
on the Forced Operation position, the operating
conditions are automatically set as follows:
During Forced Operation, the initial mode continues.
Auto restart
In case the power comes on again after a power failure,
Auto Restarting Operation is the function to operate
procedures automatically to the previous operating
conditions.
If you want to use this operation, Open the front panel
upward and move the slide switch to the Auto Restart
position.
If you do not want to use this operation, move the Slide
Switch to the Remote Control position.
Heat pump Model
Cooling Model
Room Temp. ≥ 24°C21°C ≤ Room Temp. < 24°C Room Temp. < 21°C
Operating mode Cooling Cooling Healthy Dehumidification Heating
Indoor FAN Speed
High High
Healthy Dehumidification Rule
High
Setting Temperature
22°C22°C23°C24°C
HELPFUL INFORMATION
Fan speed and cooling capacity.
The cooling capacity indicated in the specification is the
value when the fan speed is set to high, and the capacity will
be lower at low or medium fan speed.
High fan speed is recommended when you wish to cool the
room quickly.
High
Speed
When you are out for a while, put the
Slide Switch on the Remote Control.