Filter
Top Products
ATX Installation and User’s Guide
Page 9
How to access Setup Modes
1. Select the setup mode to enter by pressing the SET button for
the period of time defined in the table below.
2. When the mode changes to the selected setup mode, the
functions of the selected mode will flash.
3. Change the values of the functions by pressing UP / DOWN
button.
4. Press the SET button to enter selection. When the setup process
is complete, it returns to a normal display.
Normal operation resumes if no buttons are pressed for 5 minutes.
Set item
SET button Set mode
Master Repeater
2 seconds or
shorter
Time zone set
mode
Time zone, D.S.T Invalid
2 – 7 seconds
Manual time set
mode. (Do not
use this feature).
Year, Month / Day,
Hour / Minute
Year, Month / Day,
Hour / Minute
Channel Status,
TX Channel
Channel Status, TX
channel, RX Channel,
Layer
7 seconds or
longer
Link set mode*
Only display:
WWVB Elapsed
Time
Only display:
Linkage Elapsed Time,
WWVB Elapsed Time
*This is an advanced setting that will rarely be required. If you have
multiple transceivers and are experiencing synchronization
problems please review the document ID #888 – “Some clocks are
not correcting to time signals” located on our Knowledge Base at
http://www.lathem.com/support/knowledge-base.aspx.
Search under Airtime Wireless | ATX Mini Transceiver.