Filter
Top Products
ATX Installation and User’s Guide
Page 6
Repeater Mode (Used in Multiple ATX Installations)
In Repeater mode, the ATX receives time signals from another ATX
transceiver, and rebroadcasts the signal to other ATX Repeaters or
AirTime wall clocks.
Setup (Repeater Mode)
1. Remove the back cover and slide the Mode Selection switch to
the Repeater position.
2. Insert two (2) CR123A lithium batteries and replace the back
cover or connect the optional 6VDC adapter if it will be used.
3. Press the Reset button. The display will appear with dashes and
the RECV indicator will flash.
4. Press the TRNS button on the ATX that is set to “Master” mode.
5.
Install the Repeater ATX at the desired location (within
approximately 150 feet of the ATX Transceiver).