Filter
Top Products
ATX Installation and User’s Guide
Page 7
6.
When the signal is received from the “Master”, the term “LINK”
will display and the time and date will update to the Masters
time.
7. The TRNS indicator will flash while the ATX Repeater transmits
to AirTime wall clocks or other ATX Repeaters. The ATX will
transmit for one hour, allowing you to setup and install your
AirTime wall clocks and other ATX Repeaters.
If the Repeater ATX fails to receive the signal from the Master
ATX Transceiver (indicated by a LED flashing red or the display
toggling between time and date and
“E”
), then press the Reset
button or move the ATX to a location that is closer to the Master
ATX.
MAKE CERTAIN THAT THE REPEATER ATX DISPLAYS “LINK”.
Unless your Repeater ATX continuously receives signals from the
Master ATX, then your clock system will not operate properly.
The setup of the ATX in Repeater Mode is now complete. You
can now synchronize and install your AirTime Wall Clocks using
the instructions furnished with them.