Filter
Top Products
- 9 -
Note:
The yarn must lie correctly between the two discs of
the thread tension selector.
Thread tension selector q w
Thread routing on from the thread guide plate 8
further thread routing
3. Guide the yarn, as shown, from front to back
through the eyes of the needles.
4. Pull the end of the thread about 10 cm (4“ )
out from the eyes of the needles. Lift the sewing
foot o and slide the thread under it; then lower
the sewing foot o back down. The lever for lifting
and lowering the sewing foot o is located at the
rear of the machine, above the sewing lever rod
system.
Position the lever to lift the sewing foot o
Trial run
When yarn has been threaded for the first time,
or after a yarn breakage it must be rethreaded,
proceed as follows:
Lift the sewing foot o.
Hold the ends of the threads between the fingertips
of your left hand, slowly turn the handwheel 6 two
or three times towards yourself and then check the
threads once again.
IB_KH4300_33077_LB6.qxd 02.06.2009 13:40 Uhr Seite 9