Filter
Top Products
- 8 -
Thread tension selector 2 e
4. Pull the end of the thread about 10 cm (4”) out
from the looper eyelet.
5. Lift the sewing foot o and slide the thread under
it; then lower the sewing foot o back down. The
lever for lifting and lowering the sewing foot o
is located at the rear of the machine, above the
sewing lever rod system.
Position the lever to lift the sewing foot o
Thread routing behind the front flap 8
Thread routing on from the thread guide plate 8
Threading yarns into the needle
For simplification, the individual steps are numbered
on the illustrations (1
q
, 2
w
, 3
e
, 4
r
, ...).
1. Turn the handwheel 6 to yourself until the needles
stand fully at the top.
2. Thread the left and right yarns as shown.
Thread tree 1 (on the left)
Thread guide r and thread guide plate t
(on the left)
IB_KH4300_33077_LB6.qxd 02.06.2009 13:40 Uhr Seite 8