Filter
Top Products
- 7 -
11 Troubleshooting
Do not perform any modifications or repairs on the product!
Safety-relevant parts may only be repaired by a specialist.
Problem/Fault
Possible Cause(s) Remedy
The fastening screws cannot be screwed
tightly or were turned too far during instal-
lation.
Replace the screws and nuts Only use
screws that match the original screws;
contact the manufacturer or retailer for
information.
The fan does not start. Building fuse or circuit breaker defective. Check the building fuse or circuit breaker
and replace if necessary.
The direction switch is positioned in the
middle.
Set the direction switch to the up or down
position.
Set the pull chain switch to the "OFF" setting. Pull the pull chain once.
Loose cable plug.
ƽ
DANGER
:
Disconnect the fan from the mains network
before checking the cable plug. Check the
cable plug.
Fan defective. Have the ventilator checked by specialists
or send it to Customer Services (Address -
see Chapter "Warranty and Service").
Fan runs loudly or sways significantly. Blade mounts not firmly connected. Check the screw connection of the blade
mounts.
Blade damaged.
Check the blades, replace if necessary.
Blade not balanced out. Change the positionings of the blades
amongst themselves.
Loosen blade attachment(s). Check the blade attachments.
Fan is not hung correctly.
ƽ
DANGER
:
Disconnect the fan from the mains network
before checking whether it is hung correctly.
Check the fastening of the installation plate
and extension rod, and correct any improper
fastening.
Light does not function. Bulb defective. Check the halogen bulbs and replace
defective bulbs.
Loose cable plug.
ƽ
DANGER
:
Disconnect the fan from the mains network
before checking the cable plug. Check the
cable plug.
IB_KH1150_E2679_LB4 31.01.2008 8:41 Uhr Seite 7