Filter
Top Products
- 6 -
7 Operation
7.1 Setting the Speed
Adjust the speed level with the pull chain (G) on the motor housing. Each
pull changes the speed in the following sequence:
Fast - medium - slow - OFF
Switch the lamps on and off with the middle pull chain (F).
If the fan is also to be switched on and off with a switch or a circuit breaker, it
will start at the last speed set, unless it was switched off using the pull
chain.
7.2 Setting the Direction
INFO: Direction
The fan turns counterclockwise:
Classic fan function. The downward air flow creates a cooling effect.
Typically used during warm times of the year.
The fan turns clockwise:
The air flow is directed toward the ceiling. The heated room air is distributed
better throughout the room and the accumulation of warm air near the ceiling
is prevented.
Caution:
To prevent damage to the fan motor, only operate the direction switch
when the fan is stopped.
Change the direction with the sliding switch.
Switch positions:
Up: The fan turns clockwise.
Down: The fan turns counterclockwise. (as viewed from below)
8 Cleaning
Danger:
Disconnect the fan from the mains network before cleaning it: switch off the
corresponding building fuse or circuit breaker. Touching cables or components
under power presents a life-threatening risk!
Wipe the fan off with a soft cloth, which may be slightly moistened for stubborn
dirt. Do not use any solvents, abrasive cleansers or sharp objects, e.g.
rough sponges or brushes, to avoid scratching the fan.
9 Technical data
Product Ceiling Fan KH 1150
Mains voltage 220 - 240 V
~
, 50 Hz
Rated power for fan 60 W
Lights 3 x max. 50 W GU10
Materials Metal and MDF
Dimensions 131 x 40 cm
(35 cm with the short extension rod)
Weight (incl.) 6,750 g
Labeled with
testing certification CE, GS
10 Items supplied
1x Motor in the motor housing
1x Light module with bulb holders
5x Blades
5x Blade holders
1x Ceiling attachment with covering
1x Extension rod
3x Bulbs 50 W GU10
Plugs and screws
Assembly video (SVCD)
Operating instructions
IB_KH1150_E2679_LB4 31.01.2008 8:41 Uhr Seite 6